Storage math, shown

CCTV Calc vs. camera vendor calculators

Short answer: a vendor calculator uses that vendor's own bitrate tables. CCTV Calc estimates a typical bitrate from resolution, codec, frame rate and scene, so the two can differ by 10–30% either way. When you type in the camera's configured bitrate, CCTV Calc uses your number, and the storage math matches.

Where the difference comes from

Camera vendor calculatorCCTV Calc
BitrateThe vendor's own table for its modelsAn estimate from MP, codec, fps and scene, or the configured bitrate you enter
FormulasUsually not shownPublished on How the math works
BrandsOne brandAny camera: you pick the specs
Recording modesVariesContinuous, motion (duty %), or a schedule
RAID and drivesVariesRAID 1, 5, 6, 10, headroom, overhead, drive count
UnitsOften TiB, as NVR menus show itDecimal TB, as drives are sold (TiB reads about 9% lower)
OfflineUsually a web pageWorks with no signal; nothing leaves the device

The estimate CCTV Calc uses

Unless you enter a configured bitrate, each stream starts from a reference point of 4,000 kbps for 1080p (2.07 MP) H.264 at 30 fps in a typical scene, and scales with pixel count to the power 0.8, frame rate, codec and scene. That reproduces the common vendor tables: about 2 Mbps at 1 MP, 6 Mbps at 4 MP and 12 Mbps at 8 MP.

kbps = 4000 × (MP ÷ 2.0736)^0.8 × (fps ÷ 30) × codec × scene

Codec factors: H.264 1.00, H.264+ 0.60, H.265 0.55, H.265+ 0.30. Scene factors: low (indoor, static) 0.7, medium 1.0, high (traffic, foliage, night noise) 1.4. A busy scene at night is where a vendor's typical figure and a real camera drift apart the most.

required TB = kbps × 1000 ÷ 8 × 86,400 × duty × retention days ÷ 10¹²

How to make the two match

Open the camera's stream settings, read the configured bitrate (or the average from the NVR's live view), and enter it in the group's Configured bitrate field. CCTV Calc then uses your number instead of the estimate, and the result is the same arithmetic any calculator should do. If the numbers still differ, compare units: TB on the drive label, TiB in the NVR menu.

Try it

Storage is free for good in CCTV Calc, with no account and no signal needed.

Download CCTV Calc on the App Store

CCTV Calc support and FAQ → · How the math works →